Black & Decker BD 1000i Traduction Des Instructions Originales page 9

and ensure thorough mix.
Important: Do not use a different mixing
ration and do not use pure petrol, failure to
use the correct petrol/oil mixture will cause
the engine to seize.
Do not use fuel if it is more than 2-3 months
old.
If you do not intend to use the machine for a
lengthy period, empty the tank and refill it
before you start work again.
Ensure that you do not overfill the tank
and spill petrol. (If you do spill, wipe up the
excess amount and wait until the vapors have
evaporated – danger of ignition.) Screw the
tank cover back on.
6.5 Handle assambling
Assamble the handle (1) as shown in fig. 5
7. Operation
• Check the fuel level and top it up if
necessary.
• Make sure that the generator has sufficient
ventilation.
• Make sure that the ignition cable is secured
to the spark plug.
• Inspect the immediate vicinity of the
generator.
• Disconnect any electrical equipment which
may already be connected to the generator.
7.1 Starting the engine (Fig 2)
Important: Do not use any chemical starting
agents such as highly volatile fuels or similar.
• Open the stop cock (Item 3) by turning it
down.
• Move the ON/OFF switch (Item 7) to the "I"
position.
• Pull the choke lever (Item 6).
• Start the engine with the starter cord (Item
4) by pulling the handle forcefully. If the
engine does not start, pull the handle again.
Important:
Always pull the starter cable slowly until you
feel the initial resistance before you then pull
it quickly to start the engine. Do not allow the
starter cable to whip back of its own accord.
• Push the choke lever (Item 6) back
approximately 5 to 10 seconds after the
engine has started.
7.2 Connecting consumers to the generator
• Connect the 230 V~ electrical appliances to
be powered to the socket (Item 4). Important:
This socket is allowed to be exposed to a
continuous (S1) load of 850 W and temporarily
(S2) for a maximum of 300 second to a load of
900 W.
7.3 Overload cut-out
230 V socket
• Reduce the level of power to be drawn.
Important: If an overload occurs, ensure
that the power drawn does not exceed the
generator's maximum power output and
that no defective electrical appliances are
connected.
7.3.1 DC Application(option)
a) Use the supplied DC connecting cable
to make connection to 12VDC powered
appliance. The DC output of the generator is
not treated by a precise electric circuit. Never
use it to power any precise DC instrument.
9