Confirming Communication - Sony VAIO VGP-WKB1 Mode D'emploi

7
To stop using the keyboard and mouse
Disconnect the receiver cable from the USB port of the computer.
You can disconnect and connect the receiver cable without turning off the
computer. You can conserve battery power by turning off the keyboard and
mouse when not in use.

Confirming communication

Perform this procedure with the receiver connected.
1
2
3
If the pointer does not move accordingly in the steps above, communication
is not enabled properly. Repeat the steps described in "Enabling
communication between the keyboard and mouse and the receiver" (page
13).
GB
14
Press the CONNECT button on the mouse.
Communication between the mouse and the receiver starts.
Note
If another VGP-WKB1 wireless keyboard is being used nearby, it may interfere with
communication between the keyboard and mouse and the receiver. Enable
communication at different times or at a distance from each other.
Press the Windows key on the keyboard, and check to see
that the "Start" menu appears.
Move your finger on the pointing device, and check to see
that the pointer moves in the same direction on the screen.
Move the mouse, and check to see that the pointer moves in
the same direction on the screen.
CONNECT button