Panasonic CZ-02RT11P Manuel D'installation page 4

3. Wire the indoor unit
1 indoor unit
2 lower part of the remote controller
3 upper part of the remote controller
4 wired from the rear
5 wired from the top
6 notch the part for the wiring to pass through
with nippers, etc.
Connect the terminals on top of the upper part of the
remote controller (P1, P2), and the terminals of the
indoor unit (P1, P2). (P1 and P2 do not have polarity.)
NOTE When wiring, run the wiring away from
the power supply wiring in order to avoid
receiving electric noise (external noise).
Wiring specifications
Wiring type
2 wire
NOTE Peel the shield for the part that has to
pass through the inside of the remote
controller case (
4. Reattach the upper part of the
remote controller
Be careful not to pinch the wiring when
attaching.
Refer to figure 4:
First begin fitting from the clips at the bottom.
Installation manual
2
(Refer to figure 6)
Size
2
0.75–1.25 mm
l
). Refer to figure 5.
NOTE 1. The switch
connection are not included.
2. Do not directly touch the PC board
with your hand.
If controlling one indoor unit or one
group of indoor units with two remote
controllers
Change the MAIN/SUB changeover switch setting as
described below (Refer to figure 3).
1 Main remote controller (factory set)
2 Sub remote controller
Set one remote controller to "main", and the other to
"sub".
NOTE 1. If controlling with one remote controller,
be sure to set it to "main".
2. Set the remote controller before turning
the power supply on.
"88" is displayed for about one minute when the
power supply is turned on. During this time the
remote controller can not be operated.
box and wiring for
CZ-02RT11P
Remote controller
4PW15514-1