Automatic Shut-Off - Philips AVENT SCH540 Mode D'emploi

EngliSH
10

Automatic shut-off

Both the soother thermometer and the digital flexible-tip thermometer switch off automatically if
the thermometer has not been used for 10 minutes.
Error function
Both the soother thermometer and the digital flexible-tip thermometer have an error function.
In case of malfunction, the display shows an 'E'. Proceed as follows if this happens:
1 Press the on/off button I to switch off the thermometer.
 Press the on/off button I again to switch on the thermometer again.
Cleaning
Do not use abrasive cleaning agents, anti-bacterial cleaning agents or chemical solvents. Excessive
concentration of cleaning agents may eventually cause plastic components to crack. Do not use
cracked parts.
Clean the regular soother, the soother thermometer and the flexible-tip thermometer after each
use to ensure optimal hygiene.
Be careful not to damage the parts when you clean them.
Cleaning the soother thermometer
Before first use, wash and rinse the soother thoroughly.
Clean the soother before each use.
Before cleaning, always remove the measurement unit from the teat and shield.
1 Turn the measurement unit 90° anticlockwise with respect to the shield.
 Pull the measurement unit straight out of the teat and shield.
Note: Be careful not to bend the tip of the measurement probe.
 Clean the thermometer measurement unit with a soft damp cloth.
Do not immerse the measurement unit in water.
Do not sterilise or boil the measurement unit.
Do not clean the measurement unit in the dishwasher, in the microwave or in a microwave
steriliser.
4 Sterilise or boil the soother and protection cap (not the measurement unit!).
The soother and cover are suitable for all forms of sterilisation.
Sterilise using an AVENT Steam Steriliser or boil in water for 5 minutes.
Do not use abrasive cleaning agents or anti-bacterial cleaners. Excessive concentration of detergents
may eventually cause plastic components to crack. Should this occur, replace immediately.
If you use a sterilising solution, follow the instructions on the package. Do not leave the soother in
the sterilising solution for longer than recommended, as this may weaken the teat.
Wash your hands thoroughly and ensure surfaces are clean before contact with sterilised
components.
5 After sterilisation, let the soother cool down for 5 minutes and squeeze out any trapped
water from the teat. This is to ensure hygiene.
To reassemble the soother thermometer:
1 Align the blocks of the measurement unit with the matching slots in the back of the shield.