Preparations; Connecting The Speakers - Yamaha CRX-N560 Mode D'emploi

Preparations

Connect speakers or antenna and turn the unit on.
Do not connect the power cable of the unit until you have finished connecting all cables.

Connecting the speakers

1
Remove the insulation from the end of
the speaker cable to expose the bare
wires.
15 mm (5/8 in.)
2
Connect the speaker to the unit, as the
illustration shows.
• Prepare speakers and speaker cables separately.
• For connection of the speakers, refer to the
owner's manual supplied with them.
Right speaker
Speaker
cable
• Take care not to allow the bare speaker wires to touch each other or any metal part of the unit. This could damage the
unit and/or the speakers.
• Make sure that left and right (L, R) connections and polarity (red: +, black: -) are correct. If connections are incorrect, the
sound will be unnatural.
• Use speakers of at least 6 Ω impedance.
• You can also connect a subwoofer with built-in amplifier to the unit.
Left speaker
2
Monaural pin cable
Subwoofer
9
En