How To Use - Panasonic ER-GB44 Mode D'emploi

Notes
• To keep charging the battery will not affect battery
performance.
• If there is noise from the radio or other sources
while using or charging the appliance, move to a
different location to use the appliance.
• You cannot operate the trimmer while charging.
• When the appliance is not used for 6 months or
more, the battery will weaken (leak battery fluid,
etc.). Fully charge the battery once every 6 months.
• You can charge the battery before it is completely
discharged. However, it is recommended
to charge when the battery is completely
discharged. The battery life depends strongly on
factors such as how it is used and stored.
• Recommended ambient temperature for charging
is 0 °C-35 °C. Battery performance may decrease
outside of the recommended temperature.
• A full charge supplies enough power for
approximately 60 minutes of use. (ER-GB44)
A full charge supplies enough power for
approximately 50 minutes of use. (ER-GB43)
(Based on dry using at 20 °C-30 °C.)
The operating time may differ depending on the
frequency of use and the operating method.
• When the appliance is charged for the first
time or it has not been in use for more than 6
months, the charging time may change or the
charge indicator lamp may not glow in the first
few minutes. In addition, the operating time may
become shorter. Please charge it for more than
19 hours in such cases.
12

How to use

Using the trimmer
Make sure that the main body is turned off.
The appliance may not operate in an ambient
temperature lower than approximately 0 °C.
1
1
Mount the comb attachment and adjust the
trimming height as needed. (See page 13.)
• It can also be used without the comb attachment.
(Trimming height: approx. 0.5 mm)
• Actual beard length will be a little longer than the
height you set.
2
2
Press the power switch to turn on
the power.
Using the comb attachment
• Make sure that the main body is turned off.
• Be careful not to cut your hand with the blade when
attaching or removing the comb attachment.
1
1
Turn the dial to the "1" position.