Writing Start Id During Playback; Erasing Start Id - Sony DAT Walkman TCD-D8 Mode D'emploi

Notes
• Start IDs which are
written during
recording or which are
written after selection,
cannot be moved.
Rewrite it after erasing.
• Start IDs cannot be
written while
flashes rapidly during
the Rehearsal function.
Note
If a Start ID is erased, the
program number which is
written on the same point
will be erased also.

Writing Start ID during playback

With the optional system adaptor kit RM-D3K or the
wired remote control RMT-D7, you can write the Start
ID without erasing the contents of the existing
recording. (For more details, refer to the Operating
Instructions manual that comes with each product.)
" " flashes when
you select the point for
Start ID, the tape-corder
plays back the segment of
the tape up to 3 seconds
from the point and repeat it 16 times (Rehearsal
function).
To adjust the selected point
Each time you press the 0 or ) button of RM-D3K
or RMT-D7, the selected point shifts backwards or
forwards in 0.3-second increments, up to a maximum
extent of about 10 seconds in either direction.
Selected point
Tape
0.3
Press the 0
button.

Erasing Start ID

With the optional system adaptor kit RM-D3K or the
wired remote control RMT-D7, you can erase the Start
IDs without erasing the contents of the existing
recording. (For more details, refer to the Operating
Instructions manual that comes with each product.)
Erasing the Start ID is possible
when the tape-corder is in the
stop or playback mode only.
0.3
Press the ) button.
21 EN
Recording