Discs - Pioneer DRM-7000 Mode D'emploi

Lock release key ... 2
Screw for use in attaching base stabilizers
DRM-7000 ... 12
DRM-3000 ... 6
Operating instructions ... 1

DISCS

Discs which may be used with the Pioneer DRM-
7000/DRM-3000
The types of discs which may be used with the Pioneer DRM-
7000/DRM-3000 vary depending on the types of drives being
used, and for further information on the types of discs which
may be used you should accordingly consult the operating
instructions provided with your drive units.
Handling the discs
÷ Avoid touching the signal surface when you use a disc.
÷ To hold it, place your fingers on the edge of the disc or the
edge of the center hole and the disc edge.
÷ Do not attach paper or stickers to the label side of the
disc. Handle discs carefully and avoid damaging the label.
÷ Discs rotate at high speed in the changer. Do not use
defective discs (e.g., cracked or considerably warped).
Such discs may damage the changer.
÷ DO NOT use non-standard discs, as these may adversely
influence this unit and other equipment.
÷ DO NOT play a disc having other shape than a circular
disc, such as heart shaped disc, or malfunction may occur.
÷ Do not use the following types of discs for they may cause
malfunction of the unit or damage to the discs:
÷ Disc which has a molding flash (projected fin) left on
the periphery as shown in the figure.
÷ Disc with its edges are rounded or tapered as shown in
the figure.
÷ Discs with adhesive surface on periphery or label face.
÷ When discs are handled within a dry environment, the discs
themselves may become charged with static electricity.
Handle discs only after touching a metal fixture or
otherwise discharging any static electricity from your body.
÷ Do not place discs in locations where they may be exposed
to dust or static electricity.
÷ The Changer can accommodate only the discs with a
diameter of 12 cm (5 in). As the Changer detects the
presence of disc with optical detection of the position at
about 5 mm (3/16 in) inside the external periphery of the
12 cm (5 in) disc, the use of a disc which is transparent at
the corresponding position (*) or a 8 cm (3 in) disc may
lead to disc detection error and to the disc damage in the
worst case. Also, the use of a 8 cm disc adapter is strictly
prohibited.
* Includes translucent "C-thru Disc" discs.
÷ This unit does not support "DualDisc (The Hybrid CD/DVD
Disc)".
Read before use
11
<DRC1285>
En