To Start The Product; To Charge The Battery - Husqvarna 120i Manuel D'utilisation

become stiff and that the bar tip sprocket
gets clogged.
To connect the battery charger
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded socket outlet.
Note: The battery does not charge if the battery
temperature is more than 50 °C/122 °F. If the
temperature is more than 50 °C/122 °F, the battery
charger makes the battery become cool.

To charge the battery

Note: Charge the battery if it is the first time that you
use it. A new battery is only 30% charged.
1. Connect the battery to the battery charger.
2. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
3. When all LEDs on the battery come on, the battery is
fully charged.
3
4. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
5. Disconnect the battery from the battery charger.
Note: Refer to the battery and battery charger manuals
for more information.
14
2 1

To start the product

1. Do a check of the power trigger and power trigger
To do a check of the power trigger
lockout. See
lockout on page 23 .
2. Push the front hand guard forward to engage the
chain brake.
3. Put the battery in the battery holder.
4. Press on the lower part of the battery until you hear
a click sound.
CAUTION: If the battery does not move
into the battery holder easily, it is not
attached correctly into the battery holder.
5. Press and hold the start/stop button until the green
LED light comes on.
To use the SavE function
This product has a power saving function, SavE. The
SavE function decreases the chain speed and gives the
longest operation time from the battery.
805 - 002 -