Console-Related Error Code - Panasonic FLYER Mode D'emploi

Console-related error code

Console
Torque sensor error
● Was the power button pressed while you were
pedalling?
Speed sensor error
● The speed sensor cannot detect the signal
correctly.
Battery authentication error
● The battery cannot be recognized as an
authentic battery (one provided at purchase).
Switch authentication error
● The console cannot be authenticated.
Switch authentication error
● The console cannot be authenticated.
Switch authentication error
● The console provided at purchase cannot be
Backlight blinks.
Motor unit error
● The motor unit is in error.
Battery communication error
● Communication with the battery is not being
performed successfully.
Overheating (motor)
● The mode has entered the protection mode
since the motor unit is overloaded.
Overheating (battery)
● The mode has entered the protection mode
since the battery is overloaded.
Bicycle mark button (Walk assistance) error
● Either the bicycle mark button (Walk assistance)
is pressed or short-circuited.
Chapter 4 Maintenance — Error codes
Description
authenticated.
Press the power button without pedalling to turn
on the power. If this does not remedy the problem,
take the electric bicycle to your dealer.
Turn the power back on again. Check the speed
sensor. If this does not remedy the problem, take
the electric bicycle to your dealer.
Mount the authentic battery (one provided at
purchase).
Update the console software to the newest
version.
Take the electric bicycle to your dealer.
Check the cable connections between the console
and the motor unit. Check the cradle contacts or
display contacts for dirt.
Mount the console provided at purchase. If this
does not remedy the problem, take the electric
bicycle to your dealer.
Take the electric bicycle to your dealer.
Remove any dirt from the battery terminals. If this
does not remedy the problem, take the electric
bicycle to your dealer.
Travel under a lighter load. After a short while, the
temperature will return to normal and the assist
function will be restored.
Travel under a lighter load. After a short while, the
temperature will return to normal and the assist
function will be restored.
Check that the bicycle mark button (Walk
assistance) is not pressed, and press the power
button to turn the power back on again. If this
does not remedy the problem, take the electric
bicycle to your dealer.
167
Remedy Page
154
150
145
―
EN
151
―
―
39
―
―
156