GE IM-4A Manuel D'utilisation Et D'installation page 15

INSTALL FILL TUBE EXTENSION
6
For models with one temperature control
(refrigerator) only:
• Cut the fill tube extension (8) to the
(refer to the template on page 38) with a
M
sharp knife or a single-edge razor blade and slide
it onto the fill tube against the stop.
7
SET POWER SWITCH TO O (off)
Set the icemaker power switch to O (off). Leave
the power switch in the O (off) position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
INSTALL THE ICEMAKER FILL CUP
8
Install the icemaker fill cup (side-mounted) (15)
into the icemaker as shown.
9
PLUG IN THE ICEMAKER
Holding the icemaker in place, insert the icemaker
power cord plug into the socket on the side or rear
wall (depending on
model), making sure the
prongs and holes are
matched. Press the plug
firmly into the socket.
Lock the plug in place by
clipping the restraints
onto each side of the
plug. Make sure the
restraints click into place.
Make sure the power cord
is still in the hook on the back of the icemaker.
Installation Instructions
M
length
8
M
15
Hook
MOUNT THE ICEMAKER
10
• Lift the icemaker so the fill tube (13) or fill tube
extension (8) (depending on model) fits in the
fill cup opening (D). Hang the icemaker on the
two mounting screws (B).
Make sure:
• The power cord is still firmly in the socket.
• The fill tube (13) or fill tube extension (8)
extends into the fill cup opening at the back of
the icemaker. (Check the rear of the refrigerator
to make sure the fill tube has not been pushed
out of the back of the refrigerator).
• The icemaker mounting screws are located in
the uppermost position of the mounting slots.
• The icemaker is level.
THEN SECURELY TIGHTEN THE ICEMAKER
MOUNTING SCREWS.
11
INSTALL THE ICE BUCKET
Place the ice bucket (9) under the icemaker.
Make sure the icemaker power switch is in the
O (off) position.
12
ATTACH WARRANTY LABEL
A label (7) is provided with this kit to record the
date of installation for warranty purposes. Apply it
to the back of the refrigerator.
13
KEEP THIS MANUAL
The warranty for the icemaker is printed in this
manual. Keep this manual with your Refrigerator
Owner's Manual.
The icemaker installation inside the freezer is now
complete. Continue to the Water Valve Assembly
section.
15
8 or 13
B
D
9