GE IM-4A Manuel D'utilisation Et D'installation page 10

ICEMAKER INSTALLATION INSTRUCTIONS L
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator ---
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
1/4" Nutdriver or adjustable wrench
REMOVE ICE CUBE TRAY SHELF
1
• Remove the two screws securing the ice cube tray
to the side wall of the freezer. Remove the tray.
• Replace the screws but do not screw them all the
way in. The screw heads should extend about
1/2" (13 mm) from the side wall of the freezer.
Installation Instructions
L
Unplug the
Sharp knife
Pliers
or R
M N P Q
PREPARE FOR INSTALLATION
2
• Remove and discard the large white plug from
the rear freezer wall.
• Remove the outlet cover with a flat-blade
screwdriver.
3 INSTALL FILL TUBE EXTENSION
• Cut the fill tube extension (8)
L
to the length (refer to the
template on page 38) with
L
a sharp knife or a single-edge
razor blade and slide it onto
the fill tube against the stop.
10
Remove
plug
8
L