Maintenance; Clean The Glass Plate And The Scanning Area; Calibrate The Scanner - HP Designjet T11 MFP Série Guide De Référence Rapide

3

Maintenance

●

Clean the glass plate and the scanning area

●

Calibrate the scanner

●
Calibrate the touch screen pointer
●
Replace worn parts
Clean the glass plate and the scanning area
1. Turn off the scanner and disconnect the scanner power cable.
2. Push down on the two lever buttons found near the insertion slot on each side
of the scanning area lid. The scanning area lid-locking mechanism
disengages.
3. Holding both lever buttons down, place your free fingers in the insertion slot
and flip open the scanning area lid. The scanning area is exposed for cleaning.
4. Gently wipe the glass plate and the entire scanning area, including the main
cover and the roller, with a lint-free cloth dampened with a mild, streak-free,
glass cleaner.
CAUTION:
these chemicals. Do not spray liquids directly onto the scanner's glass plate
or anywhere else in the scanner.
The lifespan of the glass plate depends on the paper types that pass across
it. Abrasive papers such as mylar may cause premature deterioration.
5. Dry the glass completely using a separate clean, dry, lint-free cloth like the
one provided with the maintenance kit.
Calibrate the scanner
HP recommends that you calibrate the scanner once a month to maintain optimum
scan quality.
NOTE: It is important that you clean the glass and the scanning area before
calibrating the scanner.
1. Before calibrating, read the scanner's online guide on how to clean the scan
area. Then turn off the scanner and clean the scan area. Calibration does not
work well if the scan area is not clean.
2. When you have finished cleaning the scan area, turn on the scanner and leave
it on for at least an hour before proceeding to the next step.
Do not use abrasives, acetone, benzene, or fluids that contain
Clean the glass plate and the scanning area 47