Table des Matières
Publicité
OBJ_BUCH-3261-001.book Page 13 Friday, January 26, 2018 7:45 PM
Secure the workpiece. A workpiece clamped with clamp-
ing devices or in a vice is held more secure than by hand.
Inserting SDS-plus Drilling Tools: Check the latching by
pulling the tool.
Replace a damaged dust protection cap immediately.
The dust protection cap largely prevents the penetration of
drilling dust into the tool holder during operation. When in-
serting the tool, pay attention that the dust protection cap
is not damaged.
Dust from materials such as lead-containing coatings,
some wood types, minerals and metal can be harmful to
one's health and cause allergic reactions, lead to res-
piratory infections and/or cancer. Materials containing
asbestos may only be worked by specialists.
–As far as possible, use a dust extraction system suitable
for the material.
–Provide for good ventilation of the working place.
–It is recommended to wear a P2 filter-class respirator.
Observe the relevant regulations in your country for the
materials to be worked.
Prevent dust accumulation at the workplace. Dust can
easily ignite.
To save energy, only switch the power tool on when using
it.
If the application tool should become blocked, switch
the machine off. Loosen the application tool.
When switching on with a blocked drilling tool, high
torque reaction can occur.
Always wait until the machine has come to a complete
stop before placing it down. The tool insert can jam and
lead to loss of control over the power tool.
Avoid unintentional switching on. Ensure the On/Off
switch is in the off position before inserting battery
pack. Carrying the power tool with your finger on the
On/Off switch or inserting the battery pack into power
tools that have the switch on invites accidents.
Product Description and Specifications
Read all safety warnings and all instruc-
tions. Failure to follow the warnings and in-
structions may result in electric shock, fire
and/or serious injury.
Intended Use
The power tool (GSR 14.4 V-EC FC2/GSR 18 V-EC FC2 with
GFA 18-H, GHA FC2 hammer adapter) is intended for ham-
mer drilling in concrete, brick and stone.
The GFA 18-H, GHA FC2 hammer adapter must be used only
with the GSR 14.4 V-EC FC2, GSR 18 V-EC FC2 and GSR
18C-60 FCcordless drill/drivers.
Bosch Power Tools
Product Features
The numbering of the product features refers to the illustra-
tion of the machine on the graphics page.
1 Mounting
2 Torque presetting ring
3 Gear selector
4 Battery pack
5 Rotational direction switch
6 On/Off switch
7 Worklight
8 Mode selector switch
9 Hammeraufsatz GFA 18-H, GHA FC2
10 Locking ring
11 Handle (insulated gripping surface)
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.
Delivery Scope
Hammer adapter with auxiliary handle.
Application tools and other accessories shown or described
are not part of the standard delivery scope.
A complete overview of accessories can be found in our ac-
cessories program.
1 609 92A 3YJ | (26.1.18)
English | 13
Publicité
Table des Matières
