Pressure Washer; Accessories; Service Information - DeWalt DP3700 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. Add RV antifreeze to hose as
shown.
5. Pull engine starter rope slowly
several times until an ti freeze
comes out of high-pressure hose
con nec tion of pump.
6. Remove garden hose from
water inlet of pump.
7. Reconnect spark plug wire.

Pressure Washer

1. Drain
all
water
from
pressure hose, coil it and store it
in cradle of the pressure washer
handle.
2. With nozzle pointed down and
the spray gun and wand in a
vertical position, squeeze trigger
to drain all water from spray gun
and wand. Store in gun holder.
3. Store chemical hose so it is protected from dam age.
4. If space is needed, handles may be removed and attached as
shown.
CAUTION: Risk of personal injury. Avoid placing hands between
handle and frame when assembling to prevent pinching.
high-

ACCESSORIES

Recommended accessories for use with your tool are available for
purchase from your local dealer or authorized service center. If you
need assistance in locating any accessory for your tool, please con-
tact D
WALT Industrial Tool Co., 701 East Joppa Road, Baltimore,
E
MD 21286, call 1-800-4-D
WALT (1-800-433-9258) or visit our web-
E
site www.dewalt.com.
DANGER: Risk of fluid injection. When using replacement lances
or guns with this pressure washer, DO NOT use a lance and/or
lance/gun combination that is shorter in length than what was pro-
vided with this pressure washer as measured from the nozzle end
of the lance to the gun trigger.
CAUTION: The use of any other accessory not recommended for
use with this tool could be hazardous. Use only accessories rated
equal to or higher than the rating of the pressure washer.

SERVICE INFORMATION

Please have the following information available for all service calls:
Model Number ____________ Serial Number ___________
Date and Place of Purchase ____________________________
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment should be performed by a D
center, a D
WALT authorized service center or other qualified
E
service personnel. Always use identical replacement parts.
15
WALT factory service
E

Publicité

Table des Matières
loading

Table des Matières