Adjusting Trimmer For User; Fitting And Adjusting The Carrying System; Adjusting The Handle - Stihl FSA 90 Notice D'emploi

English
► Rotate the mowing head (1) counterclockwise
until the stop pin (4) engages in position.
The shaft is now blocked.
► Tighten down the mowing head (1) firmly by
hand.
► Remove the stop pin (4).
7.4.2 Removing the Mowing Head
► Switch off the trimmer, push retaining latch to
position and remove the battery.
► Insert the stop pin in the bore as far as stop
and hold it depressed.
► Rotate the mowing head (3) until the stop pin
engages in position.
The shaft is now blocked.
► Unscrew the mowing head clockwise.
► Remove the fanwheel.
► Remove stop pin.
7.5 Removing and Installing Metal
Cutting Attachment
7.5.1 Mounting Metal Cutting Attachment
► Switch off the trimmer, push retaining latch to
position and remove the battery.
1
2
3
4
5
6
7
► Fit the fanwheel (5) on the shaft (6) with fan
blades facing up.
► Place the cutting attachment (4) on the fan‐
wheel (5). If you are fitting a circular saw blade
or a grass cutting blade with more than 4 cut‐
ting edges: Its cutting edges must face in the
same direction as the arrow on the deflector.
► Place the thrust washer (3) on the metal cut‐
ting attachment (4) so that its raised side faces
up.
► Place the rider plate (2) on the thrust washer
(3) so that its closed side faces up.
36

8 Adjusting Trimmer for User

► Insert the stop pin (7) in the bore as far as
stop and hold it depressed.
► Rotate the metal cutting attachment (4) clock‐
wise until the stop pin (7) engages in position.
The shaft (6) is now blocked.
► Fit the nut (1) counterclockwise and tighten it
down firmly.
► Remove the stop pin (7).
7.5.2 Removing the Metal Cutting Attach‐
ment
► Switch off the trimmer, push retaining latch to
position and remove the battery.
► Insert the stop pin in the bore as far as stop
and hold it depressed.
► Rotate the metal cutting attachment clockwise
until the stop pin engages in position.
The shaft is now blocked.
► Unscrew the mounting nut clockwise.
► Remove the rider plate, thrust washer, metal
cutting attachment and fanwheel.
► Remove stop pin.
8 Adjusting Trimmer for User
8.1 Fitting and Adjusting the Carry‐
ing System
1
2
► Put on the shoulder strap (1) or full harness
(3).
► Adjust the shoulder strap (1) or full harness (3)
so that the carabiner (2) is about a hand's
width below your right hip.
Other approved carrying systems are listed in
this User Manual,
8.2

Adjusting the Handle

FSA 90
The bike handle can be set to different positions
to suit the height and reach of the user.
► Switch off the brushcutter, push the retaining
latch to position and remove the battery.
► Hook the brushcutter from the carrying ring
into the carabiner of the carrying system.
3
2
21.
0458-709-9921-C