Assembly & Installation - Black & Decker 50 Po Guide D'utilisation

NOTE: References to left, right, front and rear of the tractor are from the operator's position,
unless otherwise stated.
• Before assembly, place the tractor on a firm, level surface, disengage the
PTO, stop the tractor engine and set the parking brake.
Tools Required
• 1/2" wrench or socket
• 7/16" wrench or socket
Assemble Mounting Brackets
To assemble the bagger
mounting assembly, locate the
mounting assembly pack and
follow these steps:
1. Attach the two hitch side
brackets to the universal
support bracket (783-
08129) using two carriage
bolts (710-0276) and wing
knobs (720-04122) from
hardware pack 689-02364.
See Figure 1.
NOTE: The hooks on the
side brackets should point
downwards and the tabs on
the rear plate point upwards as
shown in Figure 1.
2. Flip over assembly and
mount the hitch support
bracket to the mounting
assembly as shown in
Figure 2.
NOTE: It might be easier during
the mounting stage to leave
this hardware only finger tight
to facilitate lining up the hitch
hole for the clevis pin. You will
be instructed to tighten this
hardware later in this manual.
Mount Assembly on Tractor
1. Place the hooked ends of
the mounting assembly
over the shoulder bolts
on the tractor and line up
the hitch support bracket
center hole with the hole
on the tractor's hitch. See
Figure 3.
2. Install the support bracket
(783-08856), included
with the loose parts, into
the mounting assembly as
shown in Figure 4. Line the
holes up as shown.
NOTE: The support bracket is
not intended for units with a
differential lock transmission.
ASSEMBLY & INSTALLATION
3.
Mount Vertical
Support
1.
Figure 1
2.
Use this
mounting hole
3.
Figure 2
Install Hanger Assembly
1.
Figure 3
6
Install the clevis pin (711-
0309A) from hardware
pack 689-02364 into the
tractor's hitch, the support
bracket, and the mounting
assembly and secure with
a cotter pin (714-0117).
See Figure 4.
NOTE: The clevis pin can
be fed down through the
hitch plate and secured
underneath with the cotter
pin, or it may be easier
to feed the clevis pin up
through the hitch plate
hole and secure with the cotter pin on the topside. The clevis pin has two holes. It is
recommended to use the hole closest to the head of the pin for a tighter connection.
IMPORTANT! If you decided to leave the hitch support only finger tight during the
assembly process, tighten all of the hardware securely at this time.
Install the vertical
support onto the
mounting assembly of the
tractor by hooking it over
the hitch plate.
Align the center hole on
the vertical support with
the hole on the cross
mount bracket which
corresponds with the deck new bracket. 50/54 location.
size of your tractor. See
Figure 5.
• Hole A recommended for 50" & 54" decks
Secure the vertical support to the mounting assembly using a carriage bolt
(710-0276) and a wing knob (720-04122) from hardware pack 689-02364.
Refer to Figure 5.
NOTE: Some kits may contain cross-mount brackets with numerical identification
over the holes instead of letters as shown. If this is the case, use the hole
corresponding to the deck size the bagger is being installed on.
Install and secure
the hanger assembly
(683-04498B) to the
vertical support using
two carriage bolts (710-
0276), two cup washers
(736- 0242) and two
lock nuts (712-04063)
from hardware pack
689-02364. Do not
overtighten. See Figure 6.
Figure 4
Figure 5
1
1
2
2
2
Figure 6