Taking Out Of Operation; Connecting To The Gas Bottle - EINHELL PS 12 Mode D'emploi

Anleitung PS 12 - Niro
Install and ignite in strict adherence to the
instructions.
Tips for commercial use:
To conform with BGV D34 (VBG 21), DIN 4811-3
and TRF 96, a safety pressure regulator with an
integrated high-pressure safety valve must be
installed when using this device for commercial
purposes (such as fairgrounds etc.).
This regulator is not included in the shipment.
Before placing this device into service, perform a
leakage test on all connections, either with
a leakage detection spray or a foaming agent. Do not
use an open flame.
This test must not be performed while the device is
turned on.

6. Connecting to the gas bottle

To connect the heater to a gas bottle you need the
following parts:
A standard gas bottle.
A non-adjustable, DVGW-approved pressure
regulator for a maximum capacity of 1.5 kg/h to
match the gas bottle used. Operating pressure
as per the factory setting.
A DVGW-approved hose pipe of sufficient length
that can be installed without any kinks.
(part of the equipment)
A DVGW-approved leak detection spray or a
foaming agent.
1. Connect the union nut (1) of the pressure regu-
lator (2) to the gas cylinder valve thread (4) by
turning it counter-clockwise. Do not use tools –
these could damage the gas cylinder valve gas-
ket and leakage protection would no longer be
guaranteed.
2. Use an appropriate wrench size SW 17 and turn
counter-clockwise to connect the hose line (5) to
the pressure regulator output thread (6). When
doing so, you must hold a second wrench of the
correct size on the pressure regulator (faces are
provided on the pressure regulator for this pur-
pose) in order to stop the regulator being turned
or too much force being transferred. Use the
above tool to tighten the screw connection and to
guarantee tightness and prevent leaks.
3. Perform a leakage test on all connections with
the gas cylinder valve (3) open. If there are no
bubbles, the connection is tight and does not
leak.
22.04.2004 12:47 Uhr Seite 9
7. Starting up
1. Open the gas cylinder valve (Fig. 2 / Item 3).
2. Turn knob to the large flame symbol and press
down completely. At the same time, activate the
piezo ignition repeatedly. The regulating knob
must be held down for approx. 10 more seconds
after ignition until the burner remains on. If the
flame extinguishes, do not repeat this procedure
until at least 2 minutes have passed.

8. Taking out of operation

To turn off the heater, move the button to „closed"
position and close the gas bottle valve.
9. Storage / Care / Repair
Remove the pressure regulator with gas hose
and check the gasket for damage. Please
contact ISC GmbH in case of damage.
Never store the liquid gas cylinder inside the
house, under ground or in non-ventilated areas!
The party heater can be cleaned with all
standard, non-abrasive and incombustible
liquids.
Be sure to turn off the heater and allow it to cool
before commencing with the cleaning.
Caution! Never clean the heater with
pressurized water (using a water hose, steam jet
or high pressure)!
Have only approved gas fitters carry out repairs
and maintenance work on the party heater.
Only original spare parts should be used for
repairs.
Maintenance: The hose must be checked for
cracks or other damage every six months and
should be replaced as needed. Every 2 years,
the device should be subjected to a maintenance
test by a specialized dealer. The gas hose must
be checked every 5 years by a specialized
dealer and should be replaced as needed.
Pressure regulators should be replaced after five
years, as rubber gaskets and diaphragms can
become porous.
GB
9