Maintenance Safety - Citizen C101PBC Guide D'utilisation

CD/MP3 PLAYER
CD/MP3 Player
Playing a CD/MP3
This CD.-player can play Audio Discs, CD-R, Mp3 and
CD Rewritables. Do not try to play CD-ROM, CDi, VCD,
DVD or computer CD.
1 Adjust the source selector to CD.
- - -
Display: shows Briefly.
2 To open the CD door, lift the CD door at the edge
marked OPEN.
3 Insert a CD,MP3, CD-R or CD-RW with the printed side
Facing up and press the CD door gently close.
4 Press PLAY/PAUSE on the set to start playback.
5 To pause playback press PLAY/PAUSE . To resume,
Press PLAY/PAUSE again.
6 To stop CD playback, press STOP .
Note: CD/MP3 play will also stop when:
– you open the CD compartment;
– you select RADIO sound source;
– the CD/MP3 has reached to the end.
Selecting a different track
to
During playback you can use or
select a particular track.
•If you have selected a track number in the stop or
pause position, press PLAY/PAUSE to start playback.
•Press once to begining of the next track,
or press repeatedly until the desired track number
appears in the display.
once to skip back to the begining of the
•Press
current track.
begining of the
p
Different play modes: Repeat
REPEAT – plays the current track continuously
REPEAT ALL – plays the entire CD continuously
EN-4
Programming track numbers
You may store up to 19 tracks in the desired
sequence. If you like, store any track more than once.
1 In the PROG mode, press
or for
your desired track.
2 When your chosen track number appears, press
PROGRAM button once to store the track.
The display shows prog and prog briefly
followed by your selected track number.
3 Repeat steps 1 to 2 to select and store all desired
tracks in this way.
4 To play your program, press PLAY/PAUSE .
Reviewing your set program
•In the STOP mode, press PROGRAM button.
The display shows your stored track numbers
in sequence.
Erasing a program
You can erase the contents of the memory by:
– opening the CD door;
– selecting RADIO source;
– pressing STOP (twice during playback or in the stop
Position)
MAINTENANCE & SAFETY
Precautions & General Maintenance
•Place the set on a hard and flat surface so that the
system does not tilt.
•Do not expose the set, batteries or CDs to
humidity, rain, sand or excessive heat caused by
heating equipment or direct sunlight.
•Do not cover the set. Adequate ventilation with a
minimum gap of 6 inches between the ventilation
holes and surrounding surfaces is necessary to
prevent heat build-up.
•The mechanical parts of the set contain self-
lubricating bearings and must not be oiled or
lubricated.
•To clean the set, use a soft dry cloth. Do not use
any cleaning agents containing alcohol, ammonia,
benzene or abrasives as these may harm the
housing.
CD player and CD handling
•The lens of the CD player should never be touched!
•Sudden changes in the surrounding temperature can cause condensation to form and the lens of your CD player to
cloud over. Playing a CD is then not possible. Do not attempt to clean the lens but leave the set in a warm environment
until the moisture evaporates.
•Always close the CD door to keep the CD compartment dust-free. To clean, dust the compartment with a soft dry cloth.
•To clean the CD, wipe in a straight line from the centre towards the edge using a soft, lint-free cloth. Do not use cleaning
agents as they may damage the disc.
•Never write on a CD or attach any stickers to it.
X
EN-5