Section Two - TopLite International Merlin C20 Manuel D'utilisation

6
Figure 7. Clamp Mounts, Carrying Handle and Safety Anchor
Figure 8. Removing the Y-Axis Covers for Cleaning

Section Two

Setting Up Your
The Lens/Focus Assembly
Merlin-C20
and Focusing your
Remove the clear, thin protective film from the lens piece and discard. Clean the lens with a
clean, dry optics cleaning cloth available at any eye-ware/sunglasses shop. After you have set
up your Merlin, place it in "TEST"-"GoBo" mode (See section 3 of this manual) and adjust the
focus of your Merlin against a far wall or surface (See figure 2). Then return it to a regular
operating mode.
The Fuse Holder and Replacing Fuses
Your Merlin is shipped with a 84- 270 volt, 2 amp, fast-blow fuse already installed in the holder.
We have also included a spare fuse, conveniently located right inside the holder! Should you
need to replace a fuse, we recommend you quickly replace the extra fuse for next time! Then
you will never be caught without one! To swap fuses, first make sure the power switch is in the
"off" position or that the Merlin is unplugged. Then, simply pull out the holder by pulling it free
with a fingernail, small knife or flat-head screwdriver; remove the old fuse, discard and then
snap in the fresh fuse. (See figures 3 & 4) Push the holder back into the Merlin and you are
ready to power the unit up! If the new fuse should blow upon powering up the Merlin, there is a
bigger problem and you should have the unit serviced by a qualified TopLite technician.
7 7 7 7
Merlin-C20
®
® for the First Time.