Twin-Star DFH-TH-7-E Manuel D'utilisation Du Propriétaire page 6

OPERATION INSTRUCTIONS
1. Place the product upright on a flat, level, stable, heat-resistant surface, and then
plug the Power Cord into a standard 120-volt electrical outlet. The product will beep
once and the power indicator will be on.
WARNING: Operate the product in an upright position only.
Note: Any operation on the control panel will end up with a beep to indicate the
operation works.
2. Heat Setting:
a. Press the "ON/OFF" button, the product will automatically be set at low heat.
b. Press the heat button to cycle between low and high heat.
3. Timer Setting
a. Press the setting button once and the timer indicator will flash.
b. Press "+" or "-" to set your desired timer (from 1 to 9 hours). The timer will cease
flashing after 8 seconds.
c. When the timer reaches "0", the heater will turn off automatically.
d. To cancel the timer scroll to the "C" setting (located before 1 and after 9).
4. Temperature Setting
a. Press the setting button twice and the temperature indicator will flash.
b. The product is set to begin working with the temperature under Fahrenheit.
To change the Fahrenheit to Celsius, hold on the "+" and "-"at the same time for
one second.
c. Press "+" or "-"to set your desired temperature (from 59°F to 95°F). The
temperature will cease flashing after 8 seconds and display the current room
temperature.
d. The heater will run until the space reaches the set ambient temperature, it will
then cycle between low and high heat settings to maintain the set ambient
temperature.
e. To cancel the thermostat setting and run heat continuously, scroll the thermostat
to the "ON" (located before 59°F and after 95°F).
NOTE: If the space being heated is too large, the set ambient temperature may not
be reached.
5. Turn off the heater by pressing the ON/OFF button a second time.
All the indicator lights except the power indicator will turn out.
The fan will keep on working for several seconds with the power indicator blinking to
cool down the internal components.
Then unplug the product from the outlet.
E-5