Operation; Starting Engine - RedMax PSZ2465S Mode D'emploi

PSZ2465S

8. Operation

■ STARTING ENGINE

The cutting head will start rotating
upon the engine starts.
1. Feed fuel and chain oil into their
OP1
respective tanks and tighten the caps
securely. (OP1)
(1) Fuel
(2) Chain oil
2. Rest the unit on a flat, firm place. Keep
the cutting head off the ground and
clear of surrounding objects as it will
start rotating upon starting of the
engine.
OP2
3. Push the primer pump several times
until overflown fuel flows out in the
clear tube. (OP2)
4. Move the choke lever to the closed
OP3
position. (OP3)
(1)
(1) choke lever
(2) close
(2)
(3) open
(3)
5. Set the stop switch to the "RUN"
OP4
position. Place the unit on a flat, firm
(3)
place. Keep the cutting head clear of
(2)
everything around it. (OP4)
(1) stop switch
(a)
(1)
(2) RUN
(3) STOP
(a) lockout lever
(b)
(b) throttle trigger
6. Firmly grasp (a) and (b) with left hand
OP5
(OP4), pull the starter knob quickly until
engine fires. Release throttle trigger
after engine starts. (OP5)
• Avoid pulling the rope to its end or
returning it by releasing the knob. Such
actions can cause starter failures.
US-12
WARNING
IMPORTANT
7. Move the choke lever downward to
open the choke. And restart the engine.
(OP3)
8. Allow the engine to warm up for a
several minutes before starting
operation.
1. When restarting the engine
immediately after stopping it, leave the
choke open.
2. Overchoking can make the engine hard
to start due to excess fuel. When the
engine failed to start after several
attempts, open the choke and repeat
pulling the rope, or remove the spark
plug and dry it.
■ STOPPING ENGINE (OP4)
1. Release the throttle lever and run the
engine for a half minute.
2. Shift the ignition switch to the "Stop"
position. (OP4)
• Except for an emergency, avoid
stopping the engine while pulling the
throttle lever.
■ CHECKING OIL SUPPLY
OP6
• After starting the engine, run the chain
at medium speed and see if chain oil is
scattered off as shown in the figure.
(OP6)
(1) Chain oil
The oil reservoir has a capacity sufficient
to provide about 40 minutes of cutting
time (when set to deliver the minimum
flow rate, or about as long as you'll get
from a tank of fuel). Be sure to refill the oil
tank every time when refueling the saw.
NOTE
IMPORTANT
NOTE