Install Custom Panel (Model Jdb3600Awx) - Jennair JDB3600AWX Instructions D'installation

Install Custom Panel
(Model JDB3600AWX)
NOTE: The handle for the custom panel is not included.
IMPORTANT: If the handle is attached from the back of the
custom panel, the screw holes should be countersunk for the
screws heads to be flush with the panel. If the handle is attached
to the front of the custom panel, the screw lengths cannot exceed
the panel thickness. For more information on Jenn-Air
handle selection, refer to the Jenn-Air
www.jenn-air.com, or call 1-800-688-1100.
NOTES:
A customer-supplied full front panel must weigh no more than
16 lbs (7.3 kg) and must be made to specific dimensions. It is
recommended that a cabinetmaker cut the custom panel
because of the precise dimensions needed.
All mounting hardware supplied is for a ³⁄₄" (19.1 mm) thick
wood panel. If a thinner wood panel, or materials other than
wood are used, it is the customer's responsibility to obtain the
proper length screws and adjust the pilot holes accordingly.
IMPORTANT: Use a moisture-resistant sealer on both sides and
all edges of the panel to avoid damage from humidity.
With a TORX ®† screwdriver, remove three screws from both sides,
as shown; hold the outer panel up while removing the screws.
Save screws for reinstallation.
†®TORX is a registered trademark of Saturn Fasteners, Inc.
® custom
® Catalog, visit
Gently set outer panel aside. Lay the customer-supplied custom
panel face down on a covered, non-scratching surface.
Measure 9²⁹⁄₃₂" (25.2 cm) from top edge and mark a line on the
back of customer-supplied custom panel. Position the outer panel
on the back of the customer-supplied custom panel as shown, so
that the top holes in the outer panel are on the line, and both
panels are centered side to side.
Mark all four hole locations; remove outer panel. Drill ³⁄₃₂" (2.4 mm)
pilot holes ¹⁄₂" (13 mm) deep in customer-supplied custom panel.
Place the outer panel on the back of the customer-supplied
custom panel; align holes.
15