AEB TRAVELMATE-AMBER Mode D'emploi page 13

MAGNETIC MOUNTING
The mounting surface should be metal and flat. Clean the
mounting surface with a 50/50 mix of isopropyl and water and
dry thoroughly. Place the TRAVELMATE onto the mounting surface.
Note that the base should be in full contact with this surface.
The additional suction cups will make sure that the TRAVELMATE
remains firmly in its position. Remove with gentle care and do not slide.
OPERATION INSTRUCTION
• First touch lightly the on/off button, to wake up the TRAVELMATE.
• Press two seconds to switch on or off.
• Switch the flashing mode by tapping the on/off button.
CHARGING
• The voltage of the battery of the TRAVELMATE is 11,8V, so if the
battery of the vehicle is above 13V, then the battery of this beacon
can be fully charged while connected to the cigar plug. A battery
below 13V will only charge up to 80%.
• The charger type 100-240V, charges to 100%.
• The battery is fully charged when power button light changes from
red to green.
MAINTENANCE
You TRAVELMATE has been designed for trouble free operation and
is maintenance free as far as you keep it clean and do not drop it.