Troubleshooting - Danby DIM2500WDB Guide D'utilisation

TROUBLESHOOTING

Occasionally, a problem may arise that is minor in nature, and a service call may not be necessary. Use this troubleshoot-
ing guide for a possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby's
Toll Free Number 1-800-263-2629 for assistance.
PROBLEM
POWER indicator does not
illuminate.
ICE FULL indicator is on.
ADD WATER indicator is on.
ICE FULL indicator and
ADD WATER indicator are
both on.
Not making ice or not per-
forming well.
Abnormal noise
POSSIBLE CAUSE
Power source is not on.
1. Ice is full.
2.Temperature is lower than
5°C.
Water shortage.
Ice making box is in a incor-
rect position.
1. Heat output is blocked.
2. Water temperature is too
high.
3. Ambient temperature is too
high.
4. Refrigerant leaks.
Fan or pump is obstructed.
6
SOLUTION
1.Check if the power supply is appropriate.
2.Check if the power cord is connected
properly to unit and power supply.
3. Internal components may be damaged.
Maintenance by a professional is required.
1. Remove the ice.
2. Move the ice maker to a warmer place
where the ambient temperature is higher
than 5°C.
1. Add drinkable water into ice maker, and
press button.
2. Water supply system may be damaged.
Maintenance by a professional is required.
1. Check whether any foreign object is stuck
in the ice making box.
2. Internal components may be damaged.
Maintenance by a professional is required.
1. Clean any dust off the air inlet and outlet.
2. Fill with room temperature water.
3. Move the ice maker to a warmer place
where the ambient temperature is higher
than 5°C.
4. Refrigerating system may be damaged.
Maintenance by a professional is required.
1. Set up the appliance in proper location
(see page 3)