Publicité
INSTRUCTIONS FOR FIELD CONVERSION TO LPG GAS
Refer to specific instructions for each model range.
WARNING: Improper installation, adjustment, alteration, service or maintenance can cause property damage,
injury or death. Read the installation, operating and maintenance instructions thoroughly before installing or
servicing equipment.
WARNING: This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer' s
instructions and all applicable codes and requirements of the authority having jurisdiction. If the information
in these instructions is not followed exactly, a fire, an explosion, or production of carbon monoxide may result
causing property damage, personal injury or loss of life. The conversion kit should be installed by qualified service
personnel. The installation is not complete until the operation of the converted appliance is checked and meets
the manufacturers specifications per the instructions included with this kit.
CAUTION: Ensure the gas supply is shut off at the manual shut off valve before proceeding with the conversion.
Product
Charbroiler
Griddle
Thermo Griddle
Hotplate
Stock Pot Range
CAUTION: Ensure the gas supply is shut off at the manual shut off valve before proceeding with the
conversion.
1.
Switch off the gas at the main supply valve and allow the unit to cool down before beginning with the
conversion.
2.
Remove all of the grates to expose the burners and valves.
3.
Remove the burners by loosening the fastening nuts located under the rear of the burner, lift the rear of the
burner and then slide it backwards.
4.
Using a ½" wrench, loosen the brass orifice located on the end of the control valve.
5.
Apply pipe thread compound or gas-rated Teflon tape to the thread on the end of the valve to ensure a
tight gas seal. Then replace the old orifice with the new orifice from the conversion kit.
6.
Replace the burner by sliding the open end over the orifice and then secure the M5 stud through the slot in
the support bracket.
Model #
MCCCB24A
MCCCB36A
MCCCB48A
MCCMG24A
MCCMG36A
MCCMG48A
MCCTG24A
MCCTG36A
MCCTG48A
MCCHP12A
MCCHP24A
MCCHP36A
MCCSR1A
MCCSR2A
3
Parts Included
Jet #54 drill (4)
Jet #54 drill (6)
Jet #54 drill (8)
Jet #52 drill (2)
Jet #52 drill (3)
Jet #52 drill (4)
Jet #52 drill (2)
Jet #52 drill (3)
Jet #52 drill (4)
Jet #52 drill (2)
Jet #52 drill (4)
Jet #52 drill (6)
Jet #52 drill (2)
Jet #52 drill (4)
Publicité
