Publicité
BEDJET USER OPERATING MANUAL
Troubleshooting
Use this guide to address problems with your BedJet Product. If the issue still occurs, please contact
BedJet Customer Service at info@bedjet.com or +1.401.404.5250. Email is highly encouraged and may
get the fastest response. Please, do not return any product requiring service without first obtaining
Return Authorization Number (RMA) and shipping instructions.
BedJet Audible Notifications – What does the BEEP mean?
Issue
1 Beep
BedJet switched on
Cooling/heating mode ON command
received from the remote control or App
Air Flow increase/decrease command
received from remote control or App
2 Beeps
Cooling/heating mode OFF command
received from the remote control or App
3 Beeps
Remote control learning/pairing function
has been successfully accomplished
4 Beeps
User is over-cycling the Turbo-Heat mode
by running it more than 15 minutes. This
over-cycling is caused by turning the
Turbo-Heat back on over and over again
after shutoff, or constantly advancing the
auto-shutoff timer.
5 Beeps
A system monitoring error has occurred
Revision 1.0
IMPORTANT INSTRUCTIONS
Indication
www.bedjet.com
Recommendation
This is normal operation
This is normal operation
This indicates successful learning/pairing
of a remote control to the BedJet
Remote control has not been learned if 3
beeps are not made
Follow the instructions on Turbo-Heat
mode. Stop trying to over-cycle this
setting. While the BedJet machine can
handle operating in this mode
continuously, over-cycling is not good
for a person in the bed due to the very
high levels of warming.
See diagnostic table below
P a g e | 20
Publicité
