Connecting Your Speakers - Acoustic Research HT60 Manuel D'installation Et D'opération

Connecting your Speakers

The WHT24 wireless receivers are identical and can be used for either rear channel.
1. Locate the wiring coming from the top of the
speaker stand assembly.
2. Twist the end of each speaker wire.
3. Connect the wire to the back of the speaker, in
phase. IMPORTANT: All speakers in a system
must be connected with the same polarity. Con-
nect the positive (+) terminal from the Receiver
to the positive (+) terminal on the speaker. Red
typically indicates positive. Connect the negative
(-) terminal from the Receiver to the negative (-)
terminal on the speaker. Black is typically the
color code for negative.
4. Connect other end of speaker wires to the speaker
terminals on the bottom of the receiver.
5. Repeat above steps for second receiver.
FIGURE 5 - Connecting
Your Speakers
page 7
WHT24