Publicité
Hardware Overview
System
LED
PV Panel
Terminal
Note:
NTC Thermistor must be connected in order for
the battery to charge.
Interface
System LED
Reset
Button
Battery and
NTC Thermistor
Terminal
Power Terminal
PV Panel Terminals H4 connectors for solar panel
Ethernet Ports
Output LED
All manuals and user guides at all-guidesbox.com
Battery and NTC
Thermistor Terminal
Reset
Button
Description
Steady on when system is powered on;
Red when battery polarity is reversed.
Press and hold the Reset button for 10
seconds to restore factory default settings.
Press and hold the Reset button for 16
seconds if:
• The device does not respond to a factory
reset.
• The web interface is unreachable.
• There doesn't appear to be any other
noticeable activity.
Terminal block for NTC Thermistor and
battery. (NTC Thermistor must be connected
in order for the battery to charge.)
Two-pin terminal block for power (24VDC out)
Maximum open circuit voltage 60V
Supports 10/100 Fast Ethernet connections
and passive 24V, 2-pair PoE output.
Steady on when output power is enabled.
Ethernet
Ports
Power
Terminal
PV Panel
Terminal
Output
LED
Publicité
