Publicité
Towel Warmer Installation Procedure
2
Installation Instructions
1. Check all items have been received. You should have Towel Warmer and mounting discs including fixings. Read all
instructions before continuing.
2. Fix mounting discs "A" using the screws provided and in locations as shown on figure 2.
3. Mount towel warmer and slide brackets "B" over mounting discs "A".
4. Fasten Towel Warmer using set screws "C" to lock mounting discs "A" into brackets "B". Ensure the Towel Warmer is
firmly and safely fixed.
fig. 3
3
Valve Connection
1. If using a hydronic installation pack, slide escutcheon (supplied with hydronic installation pack) over 1/2" supply pipe.
2. Unscrew male threaded components including collars from valve and thread into female inlets towards the bottom of
towel warmer leg using a 12mm allen key wrench.
3. Push compression fitting on to 1/2" supply pipe and tighten 1/2" compression fitting collar on valve.
4. Seat male threaded component (now connected to towel warmer) on valve and tighten collar.
5. Insert/tighten air vent plug found at the location as shown in fig 4.
6. Check for leaks and bleed system if necessary using air vent plug.
Warning: All hydronic plumbing connections should be made in accordance with local and
national plumbing regulations. It is the responsibility of the plumber to ensure plumbing
system and towel warmer installation comply with these regulations.
(see figure 3)
(see figure 5, 6, 8 or 9)
A
C
5
C
B
Publicité
