Publicité
CHECK INSTALLATION
13
Push the icemaker back toward the rear of
the cabinet so the mounting screw hole in the
icemaker flange aligns with the mounting hole
in the freezer side wall, making sure wires are
not hanging outside of wire housing.
kit into the hole in
the flange of the
icemaker.
REMOVE THE ICE BUCKET
14
For non-counter depth modles:
bucket cover onto the ice bucket by snapping
pins into holes at the back of the ice bucket.
NOTE:
bucket (in models with "Y" in model number such
recycled.
10
Installation Instructions
INSTALLING THE ICEMAKER (Continued)
Hex Head
REMOVE FREEZER DRAWER
15
CORNER
out and up on three tabs while pushing down
on the back of the drawer.
side flange while pulling up on the corner
piece to complete the removal.
REPLACE FREEZER DOOR
16
Pull the lower basket and slide mechanism to
full extension using both hands.
basket and set to the rear of the freezer
compartment until after the freezer door is
located on slides.
CAUTION
Lifting Hazard
secure the door before lifting.
slide mechanisms.
the screws to 65 in-lb.
Then pull out the
49-60807 Rev. 3
Publicité
