Publicité
GB
Positioning the remote control at fans with downrod
sketch 1
1. Place the receiver as shown in sketch 1 and 2 into the mounting bracket. Lay the back
antenna wire on top of the receiver into the canopy.
2. Makethe electrical connection to your fan as per wiring diagram on page 9. Thehandling
of the AC power line should ensurethat it can not be damagedor pinched!
If the live to motor (L-motor) and live fan light (L-light) of your ceiling fan are con-
nected combined, they must be separated BEFORE installing your remote control receiver.
3. Install the canopyon the monting bracket.
The pull chain switch of your ceiling fan must be set on highest speed.
After setting the mainssupply backon your ceiling fan with the remote control it is ready
to be used.
Positioning the remote control at low profile fans as i.e. KISA DELUXE or FLAT
Please install the receiver of your remote control as shown schematically in sketch 3.
After the electrical connection has been set up, use the self-adhesive stickers to attach the re-
ceiver onto the ceiling. If this is not possible, i.e. due to a rendering coat, cable straps needto
be used for the mounting plate to assure that the receivercan not fall off the ceiling. Place the
10
All manuals and user guides at all-guides.com
canopy
downrod
KISA DELUXE
receiver
canopy
downrod
antenna cable into the
housing. The pull chain
switch of your ceiling
fan must be set on high-
est speed. After setting
the mains supply back on
your ceiling fan with the
remote control it is ready
to be used.
sketch 2
Publicité
