Publicité
The PFS 6 TFR HUB was designed to give the highest degree of protection against overloads, voltage
peaks, electromagnetic interference (EMI) and radio frequency interference (RFI). It protects your
computers and peripherals against damages caused by accidental overvoltages, voltage peaks, lightning,
network parasites and overloads. A resettle circuit breaker provides protection against overloads and short
circuits. This product also features a USB hub.
Insurance terms and conditions
See terms and conditions, and register within 10 days after purchase on the web site:
www.infosec.fr
Security
Please read all these instructions before installing the PFS 6 TFR HUB. It must be installed only inside a
protected location in which temperature and humidity do not exceed the limits defined in the technical
specifications section.
Installation
Plug the PFS 6 TFR HUB into a two-pole connector with earth (2P+E-10A). Plug your equipment to be
protected into the 6 protected outlets of the PFS 6 TFR HUB.
Put the switch into the "I" or "ON" position and check that the "Protected" and "Power OK" lights are on.
If it does not light on, check the electrical power supply. If the orange "Protected" light is off, do not use the
PFS 6 TFR HUB.
1. On/Off switch
The mains two-pole switch of the PFS 6 TFR HUB is used to switch the 6 outlets on and off.
2. Overload protection
When the consumption of connected equipment exceeds the authorized value, the circuit breaker opens to
protect the PFS 6 TFR HUB. To put it back into service, reduce the connected power and reset the circuit
breaker.
3. "Power OK"
Green led "Power OK" turns on: power is effective.
Green led "Power OK" is off: power is not effective.
4. Active surge protection led
Orange led "Protected" turns on: the protection is effective.
Orange led "Protected" is off: the protection is not effective.
5. Protected outlets
Outlets are used to connect equipment such as a PC, printer, monitor, scanner, modem, external CD Rom
drive, home DVD player... The space-wide outlet is used to easily connect one transformer block. They are
controlled by the mains switch.
6. Tel. / Fax / Modem / xDSL protection
The PFS 6 TFR HUB is equipped with protection against overvoltages on the telephone/fax/modem line
thanks to its 2 RJ11 connectors (6P4C). Connect the line input to the "IN" connector and use the cable
supplied to connect the "OUT" connector to the telephone/fax/modem.
7. USB Hub
The PFS 6 TFR HUB features a 4-ports bus powered USB hub. Thanks to the provided USB cable,
connect the USB "in" connector to one free USB port of your computer, then use the 4 USB "out" ports to
easily connect your digital camera, scanner, printer or MP3 player etc... : they will be automatically
detected on your computer.
In case of problem, do not disassemble the PFS 6 TFR HUB, there are no reparable parts inside it.
INFOSEC UPS SYSTEM - 4, rue de la Rigotière – 44700 Orvault – FRANCE - www.infosec.fr
Hot Line : tel : + 33 (0)2 40 76 15 82 - fax : + 33 (0)2 40 94 29 51 - hotline@infosec.fr - 11 05 08 205 10
User's instructions
User's instructions
Please, call the Hot Line.
3
Publicité
