Set Up; How To Assemble - Husqvarna HS2 Mode D'emploi

HS2

5. Set up

Hose clamps are not completely tight.
Please tighten hose clamps prior to using.
Hose clamps are left loose to extend life
of gaskets and fittings.
Oil cap gasket before using and
lubricate weekly so the gasket will seal
properly and prevent chemical leaks.
Oil check valve and keep breather
hole clear of debris. Your failure to oil
may cause the tank to collapse
and crack due to vacuum created by
pump lubricate with "3 and 1" oil.

■ HOW TO ASSEMBLE

1. Attach spray wand to spray gun and
tighten firmly.
2. If unit is fitted with pressure valve,
secure tightly.
US-6