Publicité
All manuals and user guides at all-guides.com
ASSEMBLY
All numbers in parenthesis () refer to the index number from the parts breakdown.
1. Attach the two rail sections (8) to the upright
frame (17) using bolts (7), lock washers (10) and
nuts (11).
7
7
2. Insert the hydraulic cylinder (3) from the top
side of frame. Once the cylinder is inserted into
the frame support plate (15) make sure that
the round lifting ring (16) is seated flat on the
cylinder support plate (15). Then attach the
round threaded nut (14) to the hydraulic cylinder.
Turn clockwise to screw the round nut (16) onto
threaded shaft on the ram. Tighten round nut (3).
3. Insert lower bolster pins (9) into the bottom holes
17
17
8
8
10
10
11
11
4. Locate the hydraulic hose fitting on the cylinder
3
3
16
16
15
15
14
14
5. Tighten all bolts and screws.
6
on the up right frame, then insert the lower bolster
(13) into press frame, onto lower bolster pins.
13
13
9
9
and assemble the pressure gauge (1) to the
pressure gauge connection fitting, on the top of
the hydraulic cylinder (3).
1
1
3
3
Publicité
