Publicité
NB : For the fitting to your installation: tighten the fitting or the nuts
securely using a wrench. Avoid excessive tightening, which could
break the thread or cause micro cracks which could expand over
time and the pressure of the water and cause a leak.
[Drawing part 3]
The column needs a wall fastening point.
- Identify this fastening point vertically aligned with the water
output on the top of the mixer. For the height, see the the
measurements given in the drawing.
- Drill the wall with 6mm bit with a 40 mm depth in order to
introduce a suitable wall plug into it according to the material of
your wall.
- Place the wall fastening support of the column with the suitable
screw.
[Drawing part 4]
- Engage the column into the wall fastening support
- Engage the lower part of the column into the mixer top connector
with the gasket in between to ensure the water tightness
- Tighten the lower part to the connector with a hex key
- Tighten the wall fastening support with the provided hex key
[Drawing part 5]
- Connect the flexible to the mixer and tighten with a wrench
- Connect the head of the hose
- Screw the shower head on the column
All manuals and user guides at all-guides.com
Use
The mixer allows you to use either the column head or the hose. To
switch from one to the other, it depends of the position of the spur
on the left side tap.
• Spur up : the tap is closed
• Spur facing the wall : to use the column head
• Spur in front : to use the hose
This product is equipped with a thermostatic mixer which allows
you to preserve your water temperature.
• To set a higher water temperature, turn the tap
counterclockwise.
• To set a lower water temperature, turn the tap clockwise.
Maintenance / cleaning
The proper functioning of the tap therefore requires regular
maintenance.
We therefore recommend:
- never use abrasive or corrosive products. These aggressive
products attack coatings and tarnish your faucet.
- clean the chrome surface using a mild soap or soapy water and a
soft cloth making sure to rinse well with clean water after cleaning.
- regularly clean the cartridge / tap head (at least once a year),
using of a solution of water and white vinegar (let stand overnight).
- clean the aerator-aerator by soaking it in a water / white vinegar
solution.
- activate the moving parts (inverter, lever, crosspiece, pull tab) at
least once per week to ensure smooth operation over time
Publicité
