Publicité
High-Pass Crossover
When the switch is to the left (FULL position), the high-pass crossover is bypassed . When the
switch is to the right (HPF position), the high-pass crossover is active . The high-pass crossover is
continuously variable from 50Hz to 500Hz .
AMPLIFIEr WIrING
Power Connections for the Orion Cobalt CO600.4
Orion Cobalt CO600 .4 Fuse Size: 2 x 25 AMP ATC
●
Power connections accept up to 4 AWG wire .
●
4 AWG power and ground wire recommended for optimal performance .
●
Connect 2V+ to the battery through fuse holder . This connection provides +2V main
●
power to the amplifier .
Power wire must be fused no more than 8" from battery .
●
Ground amplifier to a good chassis ground as close as possible to the amplifier .
●
Connect rEM terminal to remote turn-on lead from source unit . This connection pro-
●
vides +2V power to turn-on the amplifier .
Add extra ground wire between the negative terminal of the battery and the chassis .
●
Speaker Wiring Diagram CO600.4
The Orion Cobalt CO600 .4 amplifier offers two sets (front and rear) of two positive and two negative
output terminals for ease of connecting the speakers to the amplifier . Each amplifier is stable to 2Ω
per channel or 4 ohm per bridged channel pair .
Bridged Front & Rear
bridged
-
4Ω or 8Ω
Figure 3
Figura 3
Abbildung 3
6
All manuals and user guides at all-guides.com
2 channels
bridged
+
-
+
-
+
-
+
4Ω or 8Ω
4 channel
-
+
-
+
-
+
2Ω or 4Ω
2Ω or 4Ω
2Ω or 4Ω
2Ω or 4Ω
© 2007 directed electronics—all rights reserved
4Ω or 8Ω
4Ω or 8Ω
-
+
Publicité
