Publicité
This fine pump that you have just purchased is designed from the latest in
material and workmanship.
Before installation and operation, we recommend the following procedures :
Check with your local electrical and plumbing codes to ensure you comply
A
with the regulations. These codes have been designed with your safety in
mind. Be sure you comply with them.
We recommend that the pump be used on a separate circuit lead from
B
the home electrical distribution panel , and which is protected with a fuse
or a circuit breaker. The motor must be securely plugged into a proper
'GFCI' electrical outlet. Consult a licensed electrician for all wiring.
The ground terminal on the three prong plugs should never be removed.
C
They are supplied and designed for your protection.
Never make adjustments to any electrical appliance or product with
D
the power connected. Do not only unscrew the fuse or trip the breaker,
remove the power plug from the receptacle.
MONTHLY MANDATORY CHECK-UP :
1. Inspect the pump for any obvious condition that necessitates cleaning, correction, adjustment
or repair.
2. Clear the surroundings of any paper, leaves or other debris that might clog the input openings.
Remove anything that might float into the suction area.
3. Ensure that the pump is secure and vertical for proper operation.
4. Ensure that there is adequate clearance from any combustible materials or structure. Stored
materials must be kept away from the pump. Shelves or cabinet structures must not be in
close proximity to the pump.
5. Test the 'GFCI' outlet by pressing its test switch. This should prove that the outlet is energized
and will trip off to protect against a ground fault. Be sure to reset the 'GFCI' by pressing its
reset switch.
6. Put the necessary pail of water in the sump to prove that the pump will start when required
and that any check valve present will permit effluent to flow.
7. Observe that the plumbing can carry the effluent safely out.
APPLICATION
This submersible utility pump is designed for
a portable application, for dewatering around homes.
This pump is great for water transfer from basin,
pool cover, flooded floor, flat roof.
CAPACITY
LPH
1.5m
2080
3.0m
1900
4.5m
375
2
SAFETY INSTRUCTIONS
US GPH
Friction loss
5'
740
in pipe not
10'
500
included.
15'
100
FEATURES
Non-corrosive material.
Stainless steel mechanical rotary seal.
Thermal and overload protection.
1/6HP, 115VAC, 60Hz, 0.8A, (1.6A when start)
NOTICE
This unit is not designed for applications to
pump salt water or brine.
Use with salt water or brine will void warranty.
.
Publicité
