Publicité
Install Memory
1. Open the upper cover by unscrewing the four screws
I.
2. Install DDR2 SDRAM DIMM referring to the following figures and notices
I.
Open the ejectors
on RAM slots
3. To prolong battery life, it will not be connected to the control board of the ANS-9010 while
shipping. Please connect it to CN3 to enable the auto-backup function after DDR2 SDRAM DIMM
was properly installed. If you don't need the auto-backup function, please leave it unchanged.
CN3
All manuals and user guides at all-guides.com
The DIMM fits into the slot only
one way. Align the notch in the
DIMM with the small rib inside
the slot. With the ejectors open,
push the DIMM until it snaps
into place.
II.
II.
The ejectors close
automatically
Publicité
