Publicité
Perform the following to install the mudflap:
1.
Clean the installation area with alcohol and allow to
fully dry before installation.
2.
Set air suspension height to "Very High" by using
center display, Controls > Suspension > Very High.
3.
Turn the steering wheel fully to the left to provide
access to the working area.
4.
Carefully use a push clip removal tool or flathead
screwdriver to remove the push clips that secure
the front wheel arch liner and underside of the LH
rocker. Discard the push clips.
Caution: Discard the existing push clips. Do not
use the existing push clips to install the
Mud Flap Kit.
5.
Maneuver the mud flap in place so that the plastic
hook on the backside is secure underneath the
wheel liner and align the mud flap so that the push
clip holes are aligned.
6.
Install the opened (plastic rivet pulled out) new
push clip into the hole on the underside rocker, and
then push the plastic rivet in to close the push clip.
Note: Make sure to install the underside rocker
push clip first.
7.
Install the opened (plastic rivet pulled out) new
push clip into the wheel liner hole, and then push
the plastic rivet in to close the push clip.
8.
Perform this procedure again on the right side of
the vehicle to install the right mud flap.
9.
Set air suspension ride height back to previous
setting using the center display.
Publicité
