Publicité
If the battery is inserted into the charger when warm or
hot, the CHARGING LED indicator light on the charger
may switch on and illuminate ORANGE. If this occurs
allow the battery to cool outside of the charger from
approximately 30 minutes.
ChargEr mounting
1. This charger can be installed hanging on a wall using
two screws (not supplied)
2. Locate the placement for the charger to be wall mounted.
3. If fastening to wood studs use 2 wood screws.
4. Drill two holes 2 3/8" (6 cm) on center ensuring they
are level.
5. If fastening to drywall use wall anchors and screws to
secure the charger to the wall.
NOTE: If the battery and the charger won't be used for a
long time, please remove the battery from the charger and
pull out the AC power plug.
imPortant SaFEty inStruCtionS
1. SAVE THESE INSTRUCTIONS - DANGER: TO
REDUCE RISK OF FIRE OR ELECTRIC SHOCK
CAREFULLY FOLLOW THESE INSTRUCTIONS.
2. Confirm the voltage available at each country location
before using the charger.
3. If the sharp of the plug does not fit the power outlet, use
an attachment plug adaptor of the proper configuration for
the power outlet.
limitED Warranty
GREENWORKS TOOLS™ battery hereby warranties this
All manuals and user guides at all-guides.com
English (original instructions)
Warning
product, to the original purchaser with proof of purchase,
for a period of two (2) years against defects in materials,
parts
or
workmanship.
charger hereby warranties this product, to the original
purchaser with proof of purchase, for a period of two (2)
years against defects in materials, parts or workmanship.
GREENWORKS TOOLS™, at its own discretion will
repair or replace any and all parts found to be defective,
through normal use, free of charge to the customer. This
warranty is valid only for units which have been used
for personal use that have not been hired or rented for
industrial/commercial use, and that have been maintained
in accordance with the instructions in the owners' manual
supplied with the product from new.
itEmS not CovErED by Warranty:
1. Any part that has become inoperative due to misuse,
commercial use, abuse, neglect, accident, improper
maintenance, or alteration; or
2. The unit, if it has not been operated and/or maintained
in accordance with the owner's manual; or
3. Normal wear, except as noted below;
4. Routine maintenance items such as lubricants, blade
sharpening;
5. Normal deterioration of the exterior finish due to the use
or exposure.
tranSPortation ChargES:
Transportation charges for the movement of any power
equipment unit or attachment are the responsibility of
the purchaser. It is the purchaser's responsibility to
pay transportation charges for any part submitted for
replacement under this warranty unless such return is
requested in writing by GREENWORKS TOOLS.
5
GREENWORKS
TOOLS™
Publicité
