Publicité
Connection diagram of parking sensor
Control Box
Display
Testing
1. After the installation of sensors, turn sensors to
correct direction and arrange the wire in good
order.
2. Connect the red cable from control box to the
positive of the reverse light, the black wire to the
negative.
a. If the display does not show the rear view, check
that polarity of the power is correct; if the cables
are connected correctly, check whether the
voltage is higher than 10.5V. Also check the plug
on the display is well connected.
(D)
(C)
(B)
(A)
+Power Wire (12V)
-GND
Sensor
+Power Wire
(12V)
-GND
37
EN
Publicité
