Publicité
EN
SAFETY
ADVICE
• It is of utmost importance to assemble all of the parts according to the
directions. Do not skip any steps.
• Always wear work gloves during panel sliding.
• Always wear shoes and safety goggles when working with extruded
aluminium.
• If using a step ladder or power tools make sure that you follow the
manufacturer's safety advice.
• Do not touch overhead power cables with the aluminium profiles.
• Do not climb or stand on the roof.
• Keep children away from the assembly area.
• Do not attempt to assemble the product in windy or wet conditions.
• Dispose of all plastic bags. Keep them out of reach of small children.
• Do not lean against or push the products during construction.
• Do not position your product in an area exposed to excessive winds.
• Do not attempt to assemble this product if you are tired, have taken
drugs or alcohol or if you are prone to dizzy spells.
• Make sure there are no hidden pipes or cables in the ground before
anchoring to foundation.
• This product is designed to be used mainly as a greenhouse.
• Heavy snow load on the roof can make it unsafe to stand below
or nearby.
• Keep roof and gutters clear of snow, dirt & leaves.
• In strong winds, all openings and the door should be closed.
Greenhouse roofs should be cleared of snow in good time so
that no dangerous snow load can occur.
• Hot items such as recently used grills, blowtorches etc. must not be
stored in the product.
• Make sure to anchor the product directly to a solid foundation to
increase the product's stability and wind resistance in areas with
severe weather conditions. Make sure that there are no obstructions
between the assembly area and the final position of the product.
CARE &
MAINTENANCE
• When your product needs to be cleaned, use a soft cloth and rinse with
cold clean water.
• DO NOT use acetone, abrasive cleaners or other special detergents to
clean the panels.
• Clean the product once assembly is complete.
BEFORE &
DURING ASSEMBLY
1. Selecting a site:
- Choose your site carefully before beginning assembly.
- Choose a sunny position away from overhanging trees.
- The product must be positioned and fixed on a flat level surface.
2. Secure the product to the foundation of your choice using suitable
screws & plugs or masonry anchors
3. This is a multi-part assembly best achieved by two people.
Allow at least half a day for the assembly process.
4. Take all components & parts out of the packages.
Sort the parts and check against the content parts list.
5. Parts should be laid out close at hand.
Keep all small parts (screws etc.) in a bowl so they do not get lost.
6. Please note multi-sided profiles are used in this product.
As a result some holes in the profiles are not used during assembly.
7. Please review entire instructions before starting.
Carry out the assembly steps in exact order.
8. Please consult your local authorities if any permits are required
prior to constructing the product.
9. Please ensure you have sufficient side space for inserting the roof
panels during the assembly process.
10. Use only the parts registered in the content list,
some parts may be surplus.
11. Firmly connect the product to a level surface immediately
after completion of the assembly.
12. Anchoring this product to the ground is essential to its stability
and rigidity. It is required to complete this stage in order for your
warranty to be valid.
13. During assembly use a soft surface below the parts to avoid
scratches and damages.
14. We recommend checking for restrictions or covenants for building
this product in your area. In addition we advise to check if you
need to submit any forms or if any permit is required prior to
building the product.
(not supplied).
Publicité
