Publicité
Installation (continued)
3
Screwing the mixer to the
standpipe
NOTE: Do not reverse the hot and cold supply.
□
Screw the standpipe (D) onto the mixer (C) by
hand. Turn in a clockwise direction until it is
tight.
Front
Cold inlet
supply line
All manuals and user guides at all-guides.com
C
D
Hot inlet
supply line
4
Drilling the holes & Making the
waterline connections
□
Mark the locations for the screws with a pencil
(1). With an electric drill (2), drill three 1/4 in.
diameter holes for the screws in the oor.
Place the anchors (G) into the holes.
□
Connect the exible supply lines (3) to the water
supplies (4).
3
3
4
4
5
Please contact 1-855-HD-GLACIER for further assistance.
2
6mm dia.
1
G
Floor
HOMEDEPOT.COM
Floor
Publicité
