Publicité
SQUIDBOARD-868
Functional overview:
L1
COM
L2
Operational Characteristics
The SQUIDBOARD is very simple to connect and use. Simply wire a switch to any one or
many of the inputs and send a signal.
Pairing process will be as per the datasheet of your chosen receiver.
IMPORTANT NOTE:
As default the SQUIDBOARD is designed for use with latching buttons - to send a signal
on state change when a switch is made or broken. This means all 3 wires must be used.
If both Live wires touch the common this will put the module to sleep and will not wake
unless power is cycled to the unit.
*Soldering to or otherwise modifying the SQUIDBOARD will invalidate the warranty.
The board comes with a 3V
AAA battery pack.
Battery or
PSU
L1
COM
L2
DS-SQUIDBOARD-868-2
SQUIDBOARD has four inputs.
Each requires a volt free switch
in order to operate.
Any inputs wires that are un-
used may be removed or just
folded out of the way.
Note: please ensure unused wires
are insulated to stop false trans-
missions and battery loss.
Green transmit indicator
LED
Red battery low indicator
LED
The SQUIDBOARD is supplied
with a battery connector for
use with a 3V AAA battery
pack.
NOTE: There is no regulator
fitted to this circuit so it can-
not support the
4.5-12V stated on the PCB.
Publicité
