Schematic Diagram - Summit Commercial BIM44 G Mode D'emploi


The PC board activates the water drain pump for 20 seconds,
pumping out most of the water contained in the water reservoir.

The water can be pumped out up a rise of to 1.5m (59") or
POWER
WATER INLET
WATER DRAIN
over a horizontal length of 1.5m (59").
POWER
WATER INLET
WATER DRAIN
 If water level switch 2 closes, transmitting a low-voltage
current to the PC board, the PC board activates the buzzer
alarm, informing you that the drain pump, water level
switch or drain tube may be malfunctioning.

Schematic Diagram

Storage Bin
Drain tube
WATER VALVE
WATER FLTER
WATER VALVE
WATER FLTER
Water level switch 2
Drain fitting
Water level switch 1
Water
reservoir
Drain
pump
19
NOTE:
The outlet of the drain hose
must be raised higher than the
water surface to prevent the
drained water from flowing
back into the water reservoir.
WARNING!
If alarm buzzer sounds, turn
off the ice maker and the
water supply, remove all ice
from storage bin, and wipe up
any water that may have
overflowed. Check if there is
any water in water trough at
back of unit; if no water,
drainage pump may not be
receiving the proper amount
of
source. If the problem can be
corrected, turn on the unit
again. Also check that none
of the water lines are kinked.
If
contact SUMMIT Customer
Service.
Drain out
power. Check power
the problem remains,