Ec Conformity Declaration - Mysmüd Home Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
food. If the user has introduced too many ingre-
dients or mixture becomes non-uniform, because
of size, weight or hardness, please press Pulse at
a high speed for 1-2 sec to solve it.
~ Food size suggestion:
~ Carrot (25*15*10mm)
~ Onion (25*15*10mm)
~ Leek (30mm dia.)
~ Cabbage (30*30mm)
~ Celery (20*15*15mm)
~ Cauliflower (20*20*20mm)
5. NOTICE FOR OPERATION
1. Insert the measuring cup to the lid (align the
arrow on the cup to the "unlock "symbol on the lid
and turn it to "lock" Position). Then press down the
lid to the blender jar to close. To open, pull up by
the flap of the lid.
2. During operation, close the lid tightly to avoid
injures due to spilling or splashing of hot liquid.
3. Wind part of the power cord underneath the
unit base. Prevent rubber foot from stepping on
the power cord.
4. When the food is too thick or there is too little
liquid in the jar, the motor may be dragged to a low
speed or cease to operate. Hence, when blending
thick and sticky food, start blending from to low to
high speed. If it is still unable to blend, disconnect
the power and stir the food inside the jar using a
rubber stirrer to drive out the air trapped in food.
Then close the lid and switch on the blender to
continue the operation.
5. When overheating is sensed, the temperature
monitoring system will stop the operation of the
motor. Given the case, put the appliance in a pla-
ce with good ventilation and let it cool down for
45 minutes. The system will be reset and you may
resume the operation of appliance.
6. Keep hands and utensils out of the container
while the motor is running to prevent the possibili-
ty of severe personal injure and /or damage.
7. In making hot beverage or soup, please ensure
the lid is secured tightly to the jar to prevent it from
falling. Please be advised to start the operation at
low speed first and then gradually increase the
speed, or simply use "pulse" mode.
8. When making sauces or jam, put in between
2 and 3 cups of ingredients. The amount should
neither be too large or too little. Keep the blending
time below 2 min to prevent any burnt smell due
to overheating. Too much ingredients may lead to
overheating of the motor. In this case, wait till the
motor temperature falls before operating again.
9. Please put both liquid and soft food into the jar
before putting in hard food or
ice cubes.
10. When the operation finishes, please wait until
the blades come to a complete stop before lifting
the blender jar.
11. If you feel a burnt smell from the blender, stop
the operation immediately.
It may be caused by the abrasion at the rubber
cushion base if it is not properly assembled.
12. Do not operate continuously for over 10 minu-
te each time.

6. EC CONFORMITY DECLARATION

We declare under sole responsibility that:
Mysmüd Blender is in conformity with the essen-
tial requirements of:
~ LVD Directive 2014/35/EU
~ EMC Directive 2014/30/EU
Meeting the requirements of following standards:
~ EN 60335-2-14: 2006 + A1:2008 + A11:2012
~ EN 60335-1: 2012 + A11: 2014
~ EN 62233: 2008
~ EN 55014-1:2006+A1:2009+A2:2011
~ EN 55014-2:1997+A1:2001:A2:2008
~ EN 61000-3-2:2014
~ EN 61000-3-3:2013
6. FINAL USER'S GUARANTEE
~ The distributor guarantees its systems for two
years against any manufacturing defect, in accor-
dance with that laid down in Law RD 1/2007, 16
November (consolidated text on the General Law
for the Defence of Consumers and Users).
~ B-60326279 shall not offer guarantee for parts
suffering usual wear and tear, lack or maintenan-
ce, hits and other faults due to the improper use
of the system outside the specifications and ope-
rating limitations indicated by the manufacturer.
~ The guarantee will not be valid in the event of mi-
suse, or those cases where it has been modified
EN - 6

Publicité

Table des Matières
loading

Table des Matières