Télécharger Imprimer la page

OBI 370363 Notice Originale page 17

Publicité

Device-specific safety instructions
• The surroundings must be free of highly-flamma-
ble or explosive materials.
• The device may not be operated outdoors.
• The device may never be operated without super-
vision.
• Never put objects through the ventilation grate
into the device. Mortal danger!
• Never subject the device to water or other liquids.
• The device may neither be operated in rooms with
a bathtub, shower or swimming pool nor near
washbasins or water connections.
• The distance between the ventilation grate and
flammable objects must be at least 75 cm.
• The device may not be covered. There is danger
of fire.
• Do not use the heater in conjunction with a timer
or any other switch capable of automatic activa-
tion, as this creates a fire hazard.
• The heater must not be positioned beneath a wall
socket.
• Do not use adapters or extension cords.
• This appliance can be used by children aged from
8 years and above and by persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge if they have been
given supervision or instruction concerning use of
the appliance in a safe way and if they understand
the hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
• Children of less than 3 years should be kept away
unless continuously supervised.
• Children aged from 3 years and less than 8 years
shall only switch on/off the appliance provided
that it has been placed or installed in its intended
normal operating position and they have been
given supervision or instruction concerning use of
the appliance in a safe way and understand the
hazards involved. Children aged from 3 years and
less than 8 years shall not plug in, regulate and
clean the appliance or perform user maintenance.
• CAUTION! Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and vul-
nerable people are present.
• Symbols appearing on your device may not be
removed or covered. Signs on the device that are
no longer legible must be replaced immediately.
Read and observe the instructions for use
before using the product for the first time.
To prevent overheating, do not cover the
heater!
Your device at a glance
Note: The actual appearance of your
product may differ from the illustrations.
► P. 3, fig. 1
► P. 3, fig. 3
1. Heat level switch I
2. Heat level switch II
3. Blower switch
4. Temperature regulator
5. Air outlet
Scope of delivery
• Convector heater
• Base feet (2 x)
• Fastening screws for base feet (4 ×)
Assembly
► P. 3, fig. 2
– Fasten base feet (7) (included) to the underside of
the device with 4 screws (6).
Operation
Check before switching on!
DANGER! Risk of injury! The device
must only be put into operation if no faults
are found during the check-up. If any part
of the device is defective, it must be
replaced before the next use.
► P. 3, fig. 3
Check the safe condition of the device:
– Check whether there are any visible defects.
– Check whether all parts of the device are firmly
attached.
– Check whether the switch is on [0] before you
insert the plug into the outlet.
Heat levels
With the heat level switches (1, 2), the device can be
operated at three different output levels:
• Only switch 1 = 1250 W;
• Only switch 2 = 750 W;
• Switches 1 and 2 = 2000 W.
Temperature regulator
With the temperature regulator (4), the desired room
temperature can be set steplessly. The temperature
regulator in the device then maintains the room tem-
perature at the pre-set value through repeated short
heating.
– Switch the device on.
– Set the temperature regulator (4) to the highest
level.
– When the desired room temperature is reached,
turn the temperature regulator anti-clockwise until
the device switches off with an audible click.
The device now maintains the current room tempera-
ture.
– To increase the room temperature, turn the tem-
perature regulator (4) clockwise.
Blower
Thanks to the built-in blower, the air warmed by the
device is distributed more quickly in the room. In addi-
tion, the blower can be used as a ventilator if the heat
is switched off.
– Switch on blower with blower switch (3).
GB
17

Publicité

loading