Publicité
Pairing a device with an app
When you insert a battery into the thermometer, the red LED light will start flashing.
If the LED light does not flash, press the pairing button for 5 seconds.
Tap Add Device in the app.
Tap the GoSmart list on the left and then the Thermo-Hygrometer EGS0102 icon.
Follow the instructions in the app and enter the name and password for your 2.4 GHz Wi-Fi network.
The pairing with the app will be completed within 2 minutes; the LED light will stop flashing.
Note: If the device fails to pair, repeat the process. 5 GHz Wi-Fi networks are not supported.
Inserting/Replacing Batteries
1. Remove the back cover of the thermometer, e.g. using a screwdriver.
2. Remove the used battery.
3. Insert a new 3V CR2032 battery. Make sure you observe the correct polarity.
4. Close the cover.
If the battery is protected by a safety film, remove it first.
Use only alkaline batteries, do not use 1.2V rechargeable batteries.
GB | 8
Publicité
