Feiss Diamond 1 Instructions D'installation

Installation Instructions for
Diamond 1 Light Wall
Wall
G ENERAL RODUCT NFORMATION P
This product is listed by one of the following
" ationally ecognized esting aboratory" N R T
These fixtures are intended to be installed utilizing NEC compliant
junction boxes.
This product is suitable for damp locations.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
1A
FIXTURE BASE LAMP
SOCKET
1 Follow enclosed supplement installation instructions for electrical and fixture installation onto house outlet box.
2 Match the shape of the glass panels with the shapes on the frame, then install the glass panels by carefully inserting them
into the frame and securing them using the tabs.
3 Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
Place the frame over the fixture base and secure it in place using the Allen screw and wrench.
4
For re-lamping, reverse steps 4 and 3 to gain access to the socket.
5
I :
L
3
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
4
1
WB1770
W 1770 B
1.0
2
TAB
FRAME
ALLEN SCREW
ALLEN WRENCH